Sharp Carousel R-1210 Operation Manual & Installation Instructions page 9

|UNPACKING AND INSTALLATION INSTRUCTIONS
7 OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUC-
TIONS FOUND ON WALLAND TOP CABINET TEMPLATES.
THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON WALL AND TOP CABINET
TEMPLATES. THINS OVEN MUST BE ATTACHED TO AT LEAST ONE WALL STUD. SEE WALL CONSTRUCo
TION ON PAGE 6,
WHEN DONE WITH TEMPLATES, PROCEED TO MOUNTING SCALE PLATE SECTION.
MOUNTING SCALE PLME
Attach 2 Scale Plates _._ with tape (not included). See
Figure 6 and WALL TEMPLATE for locations.
NOTE:
This Microwave Oven may not be built-in directly over gas
or electric ovens or cooktops. To reduce the risk of fire or
electrical shock, install at least 13 3/16" above the
countertop.
J
_ S{_,ale Plates
Mounting Hate
o oOoOo OoOoOoOoO °o°o°o°o o
MOUNTING PLATE
I. Separate 4 Toggle Bolts _, packed inthe iNSTALLATION HARDWARE, from the Toggle Nuts.
2_ Match 518"holes (not instuds),drilled t hrough WALLAND TOP CABINET TEMPLATE into wall to corresponding
holes on Mounting PIate_
3. Insert Toggle Bolts into matched openings on Mounting Plate. Put Toggle Nuts on Toggle Bolts. See Figure 7.
4. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts
through the holes in the wall with the Toggle Nuts closed. Figure 8. Use Wood Screws (_ to attach the Mounting
Plate to studs.
NOTE: Before insertion, be sure you leave a space more than the thickness of the wal! between the Mounting
Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the
Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggme Nut opens, it cannot be
withdrawn from the hole; therefore make sure aH of the ToggJes are in the correct position before
insertion.
5. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you
and turn clockwise to tighten. Figure 9.
Space mere than
Figure 9
(_'__' __)' _wall
thickness ('__
Mo.oting @
Plate
_ Wall