Sharp Carousel R-1210 Operation Manual & Installation Instructions page 7

|UNPACKING AND INSTALLAIION INSTRUCTIONS
3 ELECTRICAL G ROUNDINGmNSTROCTIONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding
plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the
National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding
reduces risk of electric shock by providing an escape wire for the electric current.
WARNmNG = Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more 3-ProngPlug
protected electrical supply. It is recommended that a separate circuit serving
only the oven be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a
wal! receptacle that is properly installed and grounded. DO NOT UNDER ANY G,oo,,dio_P,,
CIRCUMSTANCES CUT OR REMOVE THE GROUNDING PIN FROM THE
PLUG.
The single grounded receptacle should be located inside the cabinet directly
above the Microwave Oven mounting location as shown in Figure 2.
NOTE:
1. If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or serviceperson.
2. Neither Sharp nor the dealer can accept any liability for
damage to the oven or personal injury resulting from failure to
observe the correct electrical connection procedures.
Radio or TV interference
Should there be any interference caused by the microwave oven
to your radio or TV, check that the microwave oven is on a differ°
ent electrical circuit, relocate the radio or TV as far away from the
oven as feasible or check position and signal of receiving antenna.
3-Prong Receptacle
/
Ground
Receptucle Box
Figure 2
Ground r_q
Receptacle_
Opening for
Power Cord
4 TOOLS RECOMMENDED {:OR mNSTALLATION
* Phillips Screwdriver
. Electric Drill
* 1/2", 5/8" and 3/32" Drill Bits
* 1ol/2" Wood Bit or Metal Hole
Cutter (if metal cabinet is used)
Saw to cut exhaust opening
(if needed)
Protective Drop Cloth for product
and range - you may also use
carton for protection
* Scissors
, Pencil
Measure
Tape