Tuning To Radio Stations - Philips AZ 1508 Instructions For Use Manual

TUNER
Tuning to radio stations
1 Select the tuner by pressing the CDTAPE-TUNER button
several times until
SMS3
appears on the display.
2 Select the wave band by using the BAND selector.
-► Display indication: the selected waveband.
3 Press TUNING m or
»\
for approx, one second and then release
the button.
-► The radio automatically tunes to a station with sufficient
strength. Display indication during automatic tuning: Srch
4 Repeat this procedure until you find a station you desire.
r
v.
To tune to a weak transmitter briefly press TUNING
or ►h as
often as necessary for optimum reception, or until the correct
frequency is indicated in the display.
Improving RADIO reception
For
FM
and
SW
(SW waveband is not applicable on all versions)
pull out the telescopic antenna. To improve the signal, incline and
turn the antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
For
MW,
direct the built-in antenna by turning the whole set. The
telescopic antenna is not needed.
Switchable tuning grid (not on all versions)
In some versions the frequency steps can be changed. Usually the
frequency step for your area has been preset in the factory.
Keep the BAND selector button pressed for more than 5 seconds.
-► The display shows either ID Dr *o'orf? Dr ,d.
9