Philips AZ 1508 Instructions For Use Manual page 15

CASSETTE RECORDER
Recording from the CD player - CD synchro start
1 Select the CD by pressing the CDTAPE-TUNER button
several times until H3 appears on the display.
2 Insert a CD and, if desired, program track numbers.
3
Press STOP-OPEN ■
A
to open the cassette compartment
4 Insert a blank cassette with the open side facing the front.
5 Close the cassette compartment by pushing it down.
6 Press RECORD • to start recording.
-► Playing of the CD or program starts automatically. It is not
necessary to start the CD player separately.
7 For brief interruptions, press PAUSE II. To resume recording,
press the PAUSE II key again.
8
To stop recording, press STOP-OPEN ■
A.
Notes: the recording can be started from different positions:
-
if the CD player is in the Pause mode, recording will start
from this very position (use SEARCH \« ortw);
- if the CD player is in the Stop mode, recording will start
from the beginning of the CD or program.
Recording from the radio or with the microphone
1 (Selecting and preparing the source)
RADIO:
Select the radio by pressing the CDTAPE-TUNER button
several times until
BSS13
appears on the display.
MICROPHONE:
Select the tape by pressing the
CDTAPE-TUNER button several times until EE0 appears on the
display. Connect a microphone with a 3.5 mm plug to the MIC
socket and set the VOLUME control to zero (monitoring during
microphone recording is not possible).
2
Press STOP-OPEN ■
A
to open the cassette compartment.
3
Insert an unprotected blank cassette with the open side facing
the front.
4 Press RECORD • to start recording.
5
For brief interruptions press PAUSE II. To resume recording press
the PAUSE ll key again.
6
To stop recording, press STOP-OPEN ■
A.
Note: When recording from the radio or a CD, you can connect a
microphone and mix the sounds. Otherwise, be sure there is no
microphone connected that could disturb your recording.
15