Table of Contents
Advertisement
Attaching Outer Beam to Column
1.
Install two M10 Washers and
two M10 x 80 Hex Bolts through the
flange on the Outer Beam (8)
and Column.
2.
Install two M10 Washers and
two M12 Nuts to the bolts to
secure the Outer Beam (8).
3.
Repeat steps 1 and 2 to attach the Inner
Beam to the other Column assembly.
Note: The legs on the Column
Base should face outward.
Attaching Inner and Outer Beams
1.
Insert the Inner Beam (6)
into the Outer Beam (8).
2.
Screw three M10 x 20 Hex Bolts (7)
onto the Nuts on the Outer Beam.
Outer Beam
Hex Bolt
3.
Hand tighten the bolts then secure
once the length of the Lathe
Stand has been determined.
Page 6
Hex Bolt
Inner Beam
For technical questions, please call 1-888-866-5797.
Hex Bolt
Washer
4.
Install a Mounting Platform (1) to the top
of each Column using
four M10 Washers,
two M10 x 80 Hex Bolts and two Nuts.
Mounting Platform
Nut
Column
Column
Outer Beam
Nuts
Washer
Hex Bolt
Washer
Column
70595
Advertisement
Table of Contents
