Table of Contents
Advertisement
(See Fig. D.)
(1) POWER switch
Press this switch to turn the power on and off.
(2) Cassette compartment
To load a cassette tape, press the EJECT button and the cassette compartment
will open. Insert a cassette with the exposed tape side facing down and the
side to be played facing you. To close the compartment, push in the
compartment door until it locks.
|
(3) INTRO SCAN «a and > buttons
Press one of these buttons to play back the first 15 seconds approximately of
each selection in the desired direction.
Once the desired selection is found,
press the PLAY button to defeat the Intro Scan mode and engage the Play
mode,
(4) COUNTER buttons
RESET: Press the RESET button to reset the counter reading to "000". It can
also be used to specity a new "000" point and cancel the previous counter
readings memorized for 0-M repeat or 0-stop operation.
MEMORY: Pressing the MEMORY button memorizes the desired counter
reading. This function is used for 0-M repeat operation.
During fast forwarding or rewinding, the tape will stop at the counter reading
point where the MEMORY button was pressed (Memory Stop).
To cancel the memorized counter reading, press the MEMORY button
again.
e
Set the AUTO MODE selector to the OFF position for Memory Stop
operation.
(5) Display
@ REMOTE CONTROL sensor
This sensor receives signals from the remote control transmitter.
Counter
Use this conter as an aid in locating points on a tape.
© Repeat/Memory function indicators
MEMO: Lights when a count number has been memorized by pressing
the MEMORY button. Pressing the MEMORY button again turns the
indicator off and erases the memory.
0-M : Lights when thé 0-M repeat function is activated: when the AUTO
MODE selector is set to 0-М REPEAT.
FULL : Lights when the FULL repeat function is activated: when
the AUTO MODE selector is set to FULL REPEAT.
O) PEAK level meters
Indicate the peaks of the signal levels during recording and playback over a
-30 dB to +12 dB range. There are separate meters for each LEFT and
RIGHT channel. These meters have a peak hold function. This function
holds the peak level for 1 or 2 seconds.
Р) Optimum recording level indicators
The optimum recording level indicators appear as lighted segments
between the numbers of the signal level scale. The highest level position of
the indicators automatically changes according to the type of tape loaded.
© NORM, Il/CrO2, IV/METAL tape type indicators
When a tape is loaded, the built in Auto Tape Selector's sensors will
automatically determine what type of tape is loaded, adjust for proper bias,
level and equalization for that type of tape, and light the corresponding
indicator.
|
e Automatic tape selection does not function for the early model Metal type
tapes which do not have the necessary detector slots.
e The deck is not designed for use with Ferrichrome (Ш/ЕеСг) tapes.
@ 00 B and ПП C noise reduction indicators
The indicators will light to indicate the activation of the corresponding Dolby
noise reduction.
(Н) MPX FILTER indicator
|
This indicator lights when the MPX FILTER is activated.
Advertisement
Table of Contents
