7.
1:
2.
TUNING
PULLEY
14
DIAL
CORD STRINGING
Turn the tuning knob until the plates of the tuning capacitor are as far
out as possible.
Fasten one end of the cord to the spring on the tuning pulley and lead it
round pulley А.
Wind the cord 3 turns round the tuning shaft and run it round pulleys B,
C and D.
Wind
the cord 1-1/2 turns round the dial pulley and tie the end to the
spring while tensioning the spring slightly. Trim off excess cord.
Turn the tuning knob fully clockwise and fix the dial pointer to the cord
at the point where it indicates "10" on Ше dial scale.
D