16 | Getting Started; Choosing Tone Or Pulse Dialing; Setting The Dial Mode; Using The Touch-Tone Services With Pulse Dialing Systems - Sony SPP-AQ25 Operating Instructions Manual

Choosing tone or pulse dialing
Sa BO I a a a aR TOI EN
For the telephone to work correctly, you must set it to the
type of your dialing system: tone or pulse dialing.
a = oe ———_——,
DIAL MODE
[ U
Setting the dial mode
Set the DIAL MODE switch to:
T (tone) if your dialing system is tone.
P (pulse) if your dialing system is pulse.
@ If you are not sure
: - Make a trial call with the DIAL MODE switch set to T.
If the call is connected, leave the switch at T.
Otherwise, set the switch to P.
Using touch-tone services with pulse dialing systems
Some services require you to use touch-tone. This is not a
problem if vour phone already uses tone dialing. If your
phone uses pulse dialing, however, you need to follow the
steps below to use these services.
For details on making calls, see the "Making calls" section
5 . §
(page 18) .
' 1 Dial the service number.
H
You only need to press TONE 2
once to turn dialing to tone; this
will remain effective until the
call is disconnected. 3
When connected to the service, press TONE
(*).
Press the dialing keys as required.
16 | Getting started