Table of Contents
Advertisement
| TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Investigate the other compo-
nents and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below,
ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
Symptom
The power does not turn
Cause
Remedy
insert into the wall outlet.
be selected automatically.
tenna of multiple elements. (P. 12)
@ The power plug is disconnected from the
@
ON.
outlet.
@ Thecause may lie inthe protection circuit.
@ Disconnect the power plug from the out-
let, and insert again.
The
unit does
not work
@ Dueto effects of static electricity whenthe
@ Press the front panel RESET button.
even
when
the buttons
air is dry.
@ Disconnect the power plug from the out-
'are pressed.
let, and insert again.
No sound is output when
@ Not properly connected.
@ Refer to pages 12, 13 and 14 and connect
a function is set.
again.
@ Sound is muted.
@ Press the MUTING
button on the remote
control unit.
@ The volume is turned down.
@ Adjust MASTER VOLUME.
|
@ The TAPE 2 MONITOR is ON.
@ Press the TAPE 2 MONITOR button.
|
@ The speaker switch Is OFF.
@ Press the SPEAKER button of terminal (A/
B) connected to the speakers.
No image is output when
@ Not properly connected.
® Refer to pages
12 and
13, and connect
|
a function is set.
again.
® The input source is not properly selected.
@ Press the correct button.
Considerable noise in ra-
@ Not received at proper frequency.
® Receive the correct frequency.
dio broadcasts
@ The antenna is not connected.
@ Connect the antenna properly. (P. 12, 13)
@ AC-3
RF and digital signal connection
@ Distance the AC-3 RF and digital signal
wires are near the antenna terminal and
wires from the antenna terminal and an-
antenna wires.
tenna wires.
oc
[FM broadcast reception]
Li
@ The FM antenna is not stretched out.
®@ Stretch out the antenna.
pe
@ Weak radio waves.
@ Change the FM antenna to an outdoor an-
=
tenna of multiple elements. (P. 12)
Oo
[AM broadcast reception]
@ The AM antenna faces inappropriate direc-
@ Select the direction and position with the
tion.
best reception state.
@ Weak radio waves.
@ Connect a 5 to 6 meter long vinyl-coated
wire to the AM antenna terminal and ex-
tend the wire outdoors, if possible. (P. 12)
@ Affected by other equipment. (Fluorescent
@® Turn off the equipment which cause noise
lamp, motor, etc.)
or move them away from the unit.
@ Distance the antenna from the equipment
which cause noise.
Broadcast stations cannot
@ Weak radio waves.
@ Change the FM antenna to an outdoor an-
43
<ARB7099>
Advertisement
Table of Contents
