Parkside 320204 Instructions Manual page 7

Use only the following battery to operate the
cordless tool:
Type:
Rated voltage:
Capacity:
Cells:
Use only the following high-speed battery
charger to charge the cordless tool:
PLG 20 A2*
INPUT:
Rated voltage:
Power consumption:
Fuse (internal):
OUTPUT:
Rated voltage:
Charging current:
Charging time:
Protection class:
* BATTERY AND CHARGER NOT INCLUDED IN
DELIVERY
Noise and vibration data:
Measured values for noise determined in accord-
ance with EN ISO 22868. The A-rated noise level
of the power tool is typically as follows:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear ear protection!
Vibration values (vector total of three directions)
determined in accordance with EN ISO 22867:
Vibration: < 2.5 m/s 2
Uncertainty K = 1.5 m/s
WARNING!
■ Also reduce the risk due to vibrations, e.g.
the risk of Raynaud's phenomenon, by taking
frequent breaks and rubbing your hands
together!
PAHE 20-Li A1
PAP 20 A3*
LITHIUM ION
(direct current)
20 V
4000 mAh / 80 Wh
10
230–240 V ~ , 50 Hz
(alternating current)
85 W
T3.15A
3.15 A
(direct current)
21.5 V
3.5 A
approx. 80 min
II / (double shielded)
L = 88 dB (A)
pA
K = 3 dB
pA
L = 106 dB (A)
WA
K = 3 dB
WA
2
NOTE
► The sound pressure level must be reduced to
such an extent that the operator's health is
not adversely affected depending on the use
and the activities to be carried out. The sound
pressure level at the workplace can exceed
80 dB (A). In this case, sound insulation
measures are required for the operator
(e.g. wearing ear protectors).
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure speci-
fied and can be used to make equipment
comparisons. The specified vibration emission
value can also be used to make an initial
exposure estimate.
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases. There is a risk of underestima-
tion of the vibration load if the power tool is
used regularly in this manner. Try to keep the
vibration loads as low as possible. Meas-
ures to reduce the vibration load are, e.g.
wearing gloves and limiting the working time.
In this case all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool
is switched on but running without load).
Explanation of symbols on the appliance:
Read the operating instructions
and safety advice before initial
operation!
Wear protective gloves!
Wear safety shoes!
Wear ear protection!
GB │ IE │ NI │ CY │
3 ■