Table of Contents
Advertisement
8.6 Stains
Set this option to add the stain phase to
a programme.
Use this option for laundry with hard
stains to remove.
When you set this function, put the stain
remover into compartment
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
8.7 Spin
With this option you can decrease the
default spin speed.
The display shows the indicator of the set
speed.
Additional spin options:
No Spin
• Set this option to remove all spin
phases.
9. BEFORE FIRST USE
1. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
2. Put a small quantity of detergent in
the compartment for washing phase.
3. Set and start a programme for cotton
at the highest temperature without
laundry.
10. DAILY USE
10.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press button On/Off to activate the
appliance.
A short tune sounds.
10.2 Loading the laundry
1. Open the appliance door.
2. Put the laundry in the drum, one item
at a time.
• Set it for very delicate fabrics.
• To compensate for the absence of
spinning, the rinse phase uses more
water for some washing programmes.
• The display shows the indicator
Rinse Hold
• Set this option to reduce creasing.
.
• The washing programme ends with
water in the drum. The drum turns
regularly to reduce creasing.
• The door stays locked. You must drain
the water to unlock the door.
• The display shows the indicator
8.8 Temperature
Set this option to change the default
temperature.
Indicator
The display shows the set temperature.
This removes all possible dirt from the
drum and the tub.
3. Shake the items before you put them
in the appliance.
Make sure you do not put too much
laundry in the drum.
4. Close the door firmly.
.
To drain the water refer to
"Draining water out after
end of cycle".
= cold water.
ENGLISH
15
.
Advertisement
Table of Contents
