Cleaning - Philips Norelco Advantage 6705X Instructions Manual

8. E N G L I S H

CLEANING

IMPORTANT
B Always switch Razor OFFand remove from charging
base before cleaning.
B Always store Razor with Protective Razor Head Cap
on shaving heads.
B Never clean, remove or replace head assembly while
motor is on.
B Do not apply pressure to combs.Do not touch razor
heads with hard objects as this may dent or damage
precision-made slotted combs.
B Do not use razor if combs are damaged or broken.
Facial injury may occur.
B After each use:Razor
1 Switch razor off.
2 Press the Razor Head Release Button located under
razor heads on front side of Razor.
3 Flip open the Razor Head Assembly and clean the razor
heads and hair chamber by running under hot water.
Water from the tap should be on a hot setting,BUTBE
CAREFUL TO TEST WATER FIRSTSOASNOT TO
BURNORSCALDHANDS.
4 Shake off excess water and close Razor Head Assembly.
B Once A Week:Charging Stand
1 Unplug the charging stand.
2 Clean the charging stand with a moist cloth.
B Every Two Months:Razor Heads
IMPORTANT: Do Not interchange the cutters and
combs.They are a matched set and if interchanged may
adversely affect shaving performance until cutters reseat
themselves.Therefore, remove, clean and replace each
set individually.
1 Switch razor OFF.
2 Press the Razor Head Release Button located under
razor heads on front side of Razor.
3 Remove the Razor Head Assembly and clean the
razor heads and hair chamber by running under hot
water. Be sure water is not too hot so as to cause
burns or scalding.
4 While holding Razor Head Assembly in one hand,press
center wheel down while turning counterclockwise to
release and lift out frame. Set frame aside.
E N G L I S H 9.