Table of Contents
Advertisement
®
Suunto ACW
Service Manual
water. Rinse it with fresh water and dry with a
soft towel.
Replacement
1. Disassemble the unit as instructed in section
6.3.1. A.
2. Press the water contact out from the case by
pressing it from the inside.
3. Clean the water contact hole.
4. Clean the replacement contact tube and core
with cleaning detergent (isopropanol). Dry
them with a soft towel.
5. Fill the water contact hole with epoxy glue
(Fig. 5.3.27 a).
6. Insert the contact tube into the hole (Fig.
5.3.27 b).
5
5
.
.
3
3
.
.
2
2
7
7
7. Insert the contact core
(Fig. 5.3.27 c).
8. Remove the excess
glue.
9. Let the glue cure
overnight.
10. Clean the contact end
mechanically to make
sure the tongue makes
good contact (Fig.
5.3.27 c).
5.3.6. R
EPLACEMENT OF THE PUSH
Required materials
• Push-button (K5774 steel), (K5814 PVD-gold)
• O-ring (K5803) (4.50 x 0.60)
When the service is necessary
The push-buttons must be replaced, if
• the push-buttons appear stiff or rigid,
• there is a leak,
• dent, nick or other damage is detected.
Replace the push-button unit and its O-rings. It is
not reasonable to disassemble and service the unit
itself.
Disassembly of the push-buttons
Version 2/2000, 14.8.2000
1. Unscrew the push-button with the push-button
2. Remove the O-ring (Fig. 5.3.29).
Reassembly of the push-buttons
1. Clean the push-button hole.
2. Install a new O-ring. Check that the O-ring is
3. Screw in the new button with the tool (Fig
4. Test the operation of the push-button.
-
BUTTONS
5.3.7. O
Does not belong to ordinary service.
Push-button contact service
Push-button contact service is carried out if the
push-buttons do not make a contact properly.
1. Disassemble the unit as instructed in section
2. Clean the contact surface of the printed circuit
tool (Fig 5.3.28. NOTE: The push-button tool
in the Figure is not the current one in use).
5
.
3
.
2
8
5
.
3
.
2
8
5
5
.
.
3
3
.
.
2
2
9
9
clean, undamaged and lubricated with a thin
film of pure silicone grease.
5.3.30). Check that it is securely fastened.
5
.
3
.
3
0
5
.
3
.
3
0
THER SERVICE MEASURES
5.3.1. A.
board and connector plate with a wooden stick
(Fig. 5.3.31). If necessary use cleaning
detergent (isopropanol).
16
Advertisement
Table of Contents
