NEC UNIVERGE SV9100 Manual page 166

166
Netlink Multiple SIP Carriers
Description
This allows the systems to register or connect to several different SIP Carriers or SIP servers at different
locations. This means that SIP trunks can be used in multiple locations.
This also means that the DSP consumption can be reduced when a SIP trunk is used by an extension on a
Secondary system.
This feature can only be used when NetLink is deployed. If NetLink is not deployed only the 6 SIP carrier
profiles of the single system can be configured.
The number of SIP carriers available depends on the number of NetLink nodes up to a maximum of 16.
This can be a combination of Carrier Mode and Networking Mode. Each Netlink secondary node can only
have one SIP Carrier configured.
Requirements
GPZ-IPLE
SIP Trunk License(s)
Capacity
Up to 400 SIP trunks can be configured across the NetLink network.
Configuration
Certain commands must be programmed on the Primary system and some commands must be
programmed on the relevant Secondary system.
The table below shows which commands should be programmed where.
To program a Secondary system PC Pro or Web Pro must be used by connecting directly to the specific
GCD-CP10.
Programming Program Primary Program each Replication (if
Command Only Secondary enabled)