Panasonic CF-VCW281 Operating Instructions Manual page 6

Cd-r/rw drive pack

Hide thumbs Also See for CF-VCW281:

Table of Contents

Available languages

_ Software Preparation (first time only)

rias G13)

Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device

Manager] - [CDROM] - [MATSHITA UJDA**** ] - [Properties] - [Settings]. Make the

settings if they have not yet been made.

@ Add a check mark for [DMA].

@ Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].

Gears ann)

Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control

Panel) - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] - [Sec-

ondary IDE Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has not

yet been made.

Using the CD-R/RW Drive Pack in the MS-DOS Mode

Mrs)

To use the CD-R/RW Drive Pack in the MS-DOS mode", configure the drive following the

steps below after performing the above preparations. If the steps listed below are performed

without completing above preparations first, the drive will not operate properly.

* In the MS-DOS mode. only CD-ROM discs are readable.

1 Select [Start], then select [Shut Down].

2 Select [Restart in MS-DOS mode], then click [OK].

3 Open the "CONFIG.SYS" file for editing by issuing the following commands:

cd (Enter)

edit config.sys

4 Move the cursor to the line containing "OAKCDROM.SYS" and delete the characters

"rem" at the beginning of the line. (Deleting "rem" causes the item to become valid.)

DEVICEHIGH=CAWINDOWSICOMMANDIOAKCDROM.SYS /D:MSCD000

(If this line is missing, add it.)

5 Press (Alt)

(CARD +CE), then(S) to save the file. Then press (Alt)

CAIO +CE), then (X) to

exit the Edit program.

6 Follow the same steps to edit the "AUTOEXEC.BAT" file.

edit autoexec.bat

Table of Contents