Related Manuals for Victorian Plumbing Monza MZBLK19
Summary of Contents for Victorian Plumbing Monza MZBLK19
- Page 1 Wall Mounted Bath Tap with Shower Kit Fitting Instructions Please follow them carefully and leave this manual with end user V2.02.24...
- Page 2 Before you begin: We recommend that this product is installed by a qualified tradesperson, Victorian Plumbing Ltd. accept no liability for products incorrectly installed, or where the correct testing procedures have not been adhered to, thus resulting in the escape of water and consequential damage.
- Page 3 Installation: Determine the fixing position for the valve and make a recess in the wall to house the valve. The depth of the recess should be 80mm to 100mm within the finished wall surface to fit the cover plate correctly. Insert the valve into the wall recess, then mark the fixing points with the mounting lugs that are cast on the valve body.
- Page 4 Diagram: Cold V2.02.24...
- Page 5 Diagrams are for illustration purposes only. Your Wall Mounted Bath Tap may superficially differ from this drawing however the installation guide steps still apply. V2.02.24...
- Page 6 Operation: Flow Control Cold Shower Operation Rotate Handle 180° Clockwise Aftercare: Always clean the surface of wall mounted bath tap to keep it bright. Attention: please do not use inappropriate tools such as sharp brushes, rough sponges, scouring pads or corrosive detergent to clean the bath tap.
- Page 7 Troubleshooting FAULT POSSIBLE CAUSE Hot and cold supplies have been plumbed the wrong direction. Bath tap only runs hot or cold after installation Faulty thermostat. Insufficient water pressure. Check the hot water supply temperature. Bath tap does not run hot enough Blockage in the hot supply.
- Page 8 www.victorianplumbing.co.uk V2.02.24...
Need help?
Do you have a question about the Monza MZBLK19 and is the answer not in the manual?
Questions and answers