Pioneer VSX-9500S Service Manual page 59

FM MODE AUTO/MONO selector switch
Use to select the auto stereo mode or monaural mode when listening
to FM broadcasts. The monaural mode has been selected when the FM.
MONDO indicator in the display section is lit.
Auto stereo mode:
Normally, leave in this mode for reception. When a stereo FM broadcast
is received, it will be automatically reproduced in stereo.
Monaural mode:
When receiving distant stations or stations with weak broadcast signals,
the input signal may be weak, thus resulting in increased noise during
FM stereo broadcasts. In this event, setting the receiver to the monaural
mode will reduce the noise. In this case, however, FM stereo broadcasts
will be reproduced in monaural sound.
NOTE:
This switch has no effect on reception of AM broadcasts.
@ TV ANT (VIDEO/TV) selector switch
This switch can be used in place of the TV ANT switch on the RF
Modulator JA-RF5 (sold separately). This is effective only when the
JA-RF5's TV ANT switch is set to the VIDEO position.
For example:
In VIDEO mode (TV-ANT indicator in the display section goes out):
Allows you to use video components connected to the receiver
In TV mode (TV-ANT indicator in the display section lights):
Connects the TV antenna, thus allowing you to view normal TV
broadcasts. The TV mode is selected while the receiver's power is off
NOTE:
© When in the VIDEO mode, no sound will be produced from the TV
set's speakers. Listen using the speakers connected to the receiver.
* Noise may be produced if the TV set's volume control is turned up.
Turn down the set's volume control when listening.
© This switch functions only when the TV ANT selector switch on the
RF Modulator is set to "VIDEO."
© This switch is set to VIDEO when the power is turned on
AVi-> Gi= i=) 0] =i FAY E> Gy 4—jalal—
@ STATION CALL RANDOM 30 CH switches
* These switches are used to preset and recall desired broadcasting
stations, "AUTO STEREO"/""MONO" switch setting, and ACOUSTIC
MEMORY mode.
Station call operation example:
If you press the [*2] key:
* One time — station 2 is selected.
* Two times — station 12 is selected.
* Three times — station 22 is selected.
NOTE:
Pressing the STATION CALL switches when a component other than
TUNER is selected causes the INPUT SELECTOR setting to switch to
TUNER.
* They are also used when performing direct access tuning.
RETURN switch
Pressing this switch returns the receiver to the following settings, the
sound level being controlled by MASTER VOLUME control knob.
* TAPE 2 MONITOR OFF
* SURROUND MODE FF
* SPEAKERS A ON
* MUTING OFF
* FRONT BALANCE CENTER
* FUNCTION TUNER
* STATION CALL 1CH*
* VIDEO ADAPTOR OFF
* When a station is not memorized in 1 CH, station search will
automatically proceed from the frequency displayed.
[DISPLAY SECTION] VSX-7500S
@ ... VSX 9500S only.
Sey
ses HUN A
@) ®D® Ow
f
td gba si e
(as) Ga Lame
Caer) Gameeee eeom
cee OS" | [ee es ae
"ne ) pa S|
woe ye
OOH OS® ©@H©®88® ® OD &
BS