Mitsubishi Electric FX-10DU-E Operation Manual page 9

4.
KEY LAYOUT AND SCREEN SYMBOLS
rn
r 7
This is the screen for designated device
DXXX
This
indicates mOIlitOdng O r set Value ChanQng
Of
monitor.
a 32-bit data register.
This is the screen for entered device
counter. Changing the value by keying in cannot
monitor.
be done
(see page 17).
This is the screen
for
d-tanging
the
set
and the contents (current values) of a data register.
value of a designated device.
Values can be changed by pressing the number
Kxxx This indicates the current value of a timer or
Kxxx This indicates the set values of a timer or counter,
keys from
0 to 9.
This is the screen for changing the
set
value
of a entered device.
Hxxx Hexadecimal numbers can be displayed and
witten in
the
data register by pressing the number
keys 0
bD
F.
-I- These
indicate the 0NX)FF conditions of
the
-1 I-
output contact
of
the timer or counter.
If a monitoring screen extends over
two
screens, an arrow is displayed. The
two R
This indicates that the reset command
of
a timer or
screens can be alternately display& by
pressing
the [MON.)
key.
counter is activated, and that the OUT command is
not activated in the case of a non-retentive timer.
Please note this is not activated by high speed
counters.
UP These indicate the operating conditions (UP/DN)
DN
of a reversible counter.
0
Pages
10
and
11
give screen display examples.
7