Disposal; Preparing The Device For Transport; Disposal Of Your Old Appliance - Bosch WQG245D5NL User Manual And Installation Instructions

Table of Contents

Advertisement

NLTransport, storage and disposal
1 8 Transport, storage
hit and throw
18.1 Preparing the device for
transport
NB!
If the device is used immediately after
transportation, the refrigerant in the
device may cause damage to the
device.
Immediately after transport, allow
the device to rest for two hours
before using it.
Tip:The device may contain residual
water and may drip during transport.
Transport the device upright.
Requirements
¡The condensed water container is
empty. Empty the condensed water
container → Page 33
¡The device is turned on.
→ "Switch on the device",
page 30
Set any program → Page 30 .
1.
Start the program
2.
→ Page 30 and wait 5 minutes.
aThe condensed water has been pumped off.
Turn off the device.
3.
"Switching off the
appliance", page 31
Remove the water drain hose from
4.
the connection point.
"Water outlet connection types",
page 15
Secure the water drain hose on the
5.
device against unintentional
loosening.
Make sure that the water
drain hose is not kinked.
46
Empty the condensed water container
6.
→ Page 33 .
Slide in the condensed water
7.
container → Page 34 .
Disconnect the plug of the device
8.
from the power supply.
aThe device is ready for trans-
port wine.
18.2 Disposal of your old
appliance
Valuable raw materials can be reused
through environmentally friendly

disposal.

WARNING
Risk of health hazard!
Children can lock themselves in the
appliance and endanger their lives.
Do not install the device behind a
door that blocks or prevents the
opening of the device door.
In the case of discarded appliances,
unplug the mains cable, then cut
the mains cable and damage the
appliance door lock to such an
extent that the appliance door no
longer closes.
WARNING
Risk of fire!
The refrigerant R290 in this appliance
is environmentally friendly but
flammable and can catch fire in
improperly disposed appliances.
Dispose of the device properly.
Make sure that the refrigerant
circuit pipes are not damaged.
Unplug the power cord from the wall
1.
outlet.
Cut the power cord.
2.

Advertisement

Table of Contents
loading

Table of Contents