General Operation; Standby/On; Select Modes; Adjust The Volume - Horizon Fitness acustico HAV-M1100N Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Standby/ON

When you first connect the main unit to the mains socket, the main unit will be in Standby mode.

Press the /SOURCE button on the unit to switch the unit ON.

Press and hold the /SOURCE button again on the unit to switch the unit back to STANDBY mode. The

indicator will light up red.

Disconnect the mains plug from the mains socket if you want to switch the unit OFF completely.

Note:

When there is no input signal (or weak input signal) in AUX, OPTICAL, COAXIAL, USB, Bluetooth (Stop or

Pause) for over 15 minutes, the unit will automatically switch to Standby mode.

When turning the system on, the system will continue in the mode it was in when it was turned off last time.

Select Modes

Press the

/SOURCE button repeatedly on the unit to switch between AUX, OPTICAL, COAXIAL, USB and

BLUETOOTH modes.

Red Light: In Standby mode

Green Light: In AUX mode

Blue Light: In Bluetooth mode

Adjust the Volume

Press the VOL +/– button on the unit to adjust the volume.

While adjusting the volume, the status indicator flashes quickly.

While the volume level reaches its maximum level, if you press the VOL+ button again, the status indicator

flashes once. While the volume level reaches its minimum level, if you press the VOL- button again, the

status indicator flashes once.

Adjust the BASS / TREBLE

Rotate the BASS knob on the unit to adjust bass level, the status indicator flashes quickly.

Rotate the TREBLE knob on the unit to adjust treble level, the status indicator flashes quickly.

1. Ensure that the unit is connected to the TV or audio device.

2. While in ON mode, press the /SOURCE button repeatedly on the unit to switch between AUX, OPTICAL,

COAXIAL mode.

3. Operate your audio device directly for playback features.

4. Press the VOL +/– button to adjust the volume to your desired level.

Tip: While in OPTICAL/COAXIAL mode, if there's no sound output from the unit and the status indicator

flashes quickly, you may need to activate PCM Signal output on your source device (eg. TV, DVD or Blu-ray

player).

USB Operation

1. Insert the USB device to the USB PLAYBACK socket on the

unit.

2. Press the /SOURCE button repeatedly on the unit to

switch between USB mode.

3. The unit will play music automatically.