Table of Contents
Advertisement
1.2
Supported OS
Supported guest OS as are as follows.
Product type
KPUB21**S
KPUB21*1S
KPUB21A2S
◇Remark
"IoT" is not displayed when Windows edition is displayed.
This is a Windows specification, and the Windows license is as shown in the table above.
◇Remark
Event ID: 10016 is registered in the event viewer. We recommend that you ignore it because it
does not adversely affect the function, similar to Microsoft's view and recommendation.
1.3
Network Configuration
This section describes the network configuration of PLC / DCS.
Physical port EN-A and EN-B are shared by PLC / DCS and Windows. Set PLC's / DCS's
and Windows' IP addresses to be assigned to the same physical port to different host
addresses within the same network address.
Table 1.2 An example of PLC Network Configuration
PUB21
nV-Tool
display
display
EN-A
LAN20
192.168.0.1
EN-B
LAN21
172.16.64.1.
◆Note
The G / L bit (normally 0) of the first half part (OUI) of the MAC address of the network card is
set to 1 on Windows. That is, the G / L bit in PLC and Windows is as follows.
0：PLC
1：Windows
◆Note
In the case of B side PUB21 of the multi base unit, the nV-Tool display of LAN20 and LAN21
becomes LAN30 and LAN31 each.
Table 1.1 Supported Model
Edition
Windows 10 IoT Enterprise LTSB 2016
Windows 10 IoT Enterprise LTSC 2019
Windows 10 IoT Enterprise LTSC 2021
IP address
MAC address
(PLC)
(PLC)
B8-6B-23-70-1B-E7
B8-6B-23-71-1B-E7
Unified Controller Vm series Controller typeS / typeL Virtualization Functional Manual
Version
32-bit
1607
64-bit
1809
64-bit
21H2
IP address
MAC address
(Windows)
(Windows)
192.168.0.2
BA-6B-23-70-1B-E7
172.16.64.2.
BA-6B-23-71-1B-E7
OS Build
14393
17763
19044
3
Advertisement
Table of Contents
