Cub Cadet PS-520 Owner's Manual page 7

e Pull up and back on the upper handle to raise the handle into the operating position. Make certain
the lower handle is seated securely into the handle mounting brackets. Tighten the hand knobs on
each side of the handle (carriage bolts must be seated properly on the handle). See Figure 4.
Carriage
Bolt
Carriage Bolt
Hand
Knob
Figure 4
NOTE: Your mower is shipped with the handle in the higher height position. If you wish to lower the height
of the handle, refer to the Handle Height Adjustment Section on page 11.
+ Remove the hairpin clips from the outer holes in the weld pins on the handle mounting brackets.
+ Using a pair of pliers, squeeze one leg of the lower handle against the handle mounting bracket.
Insert the hairpin clip into the inner hole on the weld pin. See Figure 5. Repeat on other side.
Hairpin
Clip in
Inner Hole
Lower
Handle
Handle
Mounting
Bracket
Figure 5
Slip rope into
sea a uide wee Nut
Rope E
Guide
Figure 6