Cub Cadet PS-520 Owner's Manual page 10

To Start Engine And Engage Blade
Move the throttle control on the engine to the fast (rabbit) position.
Prime engine as instructed in the engine manual.
Standing behind the unit, depress the blade control handle and hold it against the upper handle.
Grasp starter handle and pull rope out slowly until engine reaches start of compression cycle (rope
will pull slightly harder at this point). Let the rope rewind slowly.
e Pull rope with a rapid, continuous, full arm stroke. Keep a firm grip on starter handle. Return it
slowly to the rope guide.
NOTE: H any problems are encountered, refer to the Trouble Shooting Guide for helpful information.
To Stop Engine And Blade
e Release the blade control handle to stop the engine and blade.
T WARNING: The blade continues to rotate for a few seconds after the engine is shut off.
Using Your Rotary Mower
discharge towards the uncut part of the lawn. This permits recutting of the clippings to further
pulverize them. When cutting high weeds, discharge towards cut portion, then recut at right angles
to first direction.
cut in the fall as long as there is growth.
thoroughly inspect the mower for any damage, and repair the damage before restarting
and operating the mower.
Extensive vibration
of the mower during operation
is an
indication of damage. The unit should be promptly inspected and repaired.
10