Advertisement
Quick Links
Kit Contents:
A. 1x Left Arm
B. 1x Right Arm
C. 1x Back Stretcher
D. 1x Front Stretcher
E. 1x Left minifigure mount
F. 2x Right minifigure mount
G. 1x Backing adaptor
H. 2x Wall screws
I. 2x Wall plugs
Please ensure the correct orientation of the
stretchers and arms.
Wall Mount Instructions
For Lunar Lander – (10266)
A.
E.
.
H.
G.
.
.
C.
B.
.
D.
.
.
F.
.
I.
.
Advertisement
Related Manuals for GECKO BRICKS Lunar Lander
Summary of Contents for GECKO BRICKS Lunar Lander
- Page 1 Wall Mount Instructions For Lunar Lander – (10266) Kit Contents: A. 1x Left Arm B. 1x Right Arm C. 1x Back Stretcher D. 1x Front Stretcher E. 1x Left minifigure mount F. 2x Right minifigure mount G. 1x Backing adaptor H.
- Page 2 Wall Mount Instructions For Lunar Lander – (10266) If you are choosing to use the minifigure side mounts please insert them as shown before the next step. Install both screws into the back stretcher. Do not over tighten (use a...
- Page 3 Wall Mount Instructions For Lunar Lander – (10266) Adding the moon surface to the back of the lunar lander is optional. Place the included 3M command strip to the backing adaptor. Then fit this to the back of the moon surface build.
- Page 4 Wall Mount Instructions For Lunar Lander – (10266) Insert the moon surface behind the wall mount as shown. Once in place and lined up with the wall mount, press gently to adhere the 3M command strip.
- Page 5 Wall Mount Instructions For Lunar Lander – (10266) Finally install the Lunar Lander. Carefully lower the set into the mount as shown. The Lego should neatly nestle into the 3D printed geometry.
- Page 6 Wall Mount Instructions For Lunar Lander – (10266) Legacy instructions:...
Need help?
Do you have a question about the Lunar Lander and is the answer not in the manual?
Questions and answers