Table of Contents
Advertisement
A\ Caution:
Read this page carefully to keep your safety.
Before applying power
For the U.S.A. and Canada
For other countries
Important!
Units shipped to countries other than the above countries are
equipped
with an AC voltage selector
switch
on the rear
panel. Refer to the following paragraph for the proper setting
of this switch.
AC voltage selection
This unit operates on 110-120 or 220-240 volts AC. The AC
voltage selector switch on the rear panel is set to the voltage
that prevails in the area to which the unit is shipped. Before
connecting the power cord to your AC outlet, make sure that
the setting position of this switch matches your line voltage.
If not, it must be set to your voltage in accordance with the
following direction.
Note:
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector
switch.
Important!
Units shipped to the U.S.A. and Canada
are designed for
operation on 120 volts AC only.
For Australia and Europe
Important!
Units shipped to Australia are designed
for operation
on
240 VAC only.
Units shipped to Europe are designed for operation on 220 V
AC only.
For the United Kingdom
Important!
Units shipped to the U.K. are designed for operation on 240
volts AC only.
The mains plug must be removed from the wall socket prior to
any internal examination.
The wires in this mains lead are coloured in accordance with
the following code:
BUG! 502 -ccescacesozsscteeet
ieeetives hiv aeane:
Neutral
OO
—)
BOW? -cccussectccess
tena tac descetslvcssenevaeeiees
Live
Ley =
é
;
:
:
;
AC110-
AC220-
Stopper plate
=)
The
wires
in this mains
tead
must
be connected
to the
120V ~
240V~
1-2
terminals in the plug as follows:
Wire colour
Plug terminal marking
BUG) f2.ceheedathiceh
leach assiercentteseeeeteets
N or Black
BIOW cssssscscscosnscesssatoetescsstiveuntccoteanéeses
L or Red
QB
©
Ae
"iM
1-3
1-1
Brown to
'
Live
Fig. 1
7
Blue to
1. Before plugging in this unit, make sure that the position of
Neutral
the AC voltage selector conforms tok your lilne (mains)
voltage. If not, it must be reset. See Fig. 1-1.
2. To
reset
the selector,
slide the stopper
plate
to the
opposite side with a screwdriver or other pointed tool. See
Fig. 1-2.
Plug
Notes:
;
3. Injsert the power cord securely. See Fig. 1-3.
1. If a 13-amp plug is used, this must be fitted with a 5- amp
fuse.
2. If a 3-pin plug with earthing contact is used, no wire must
be connected to the E terminal.
Safety precautions
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
THE LIGHTNING FLASH WITH ARROWHEAD
SYMBOL, WITHIN AN EQUILATERAL TRIAN-
GLE, IS INTENDED
TO ALERT THE USER TO THE PRESENCE
OF UNINSULATED
''DAN-
GEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT
MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION
POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT
THE USER TO THE PRESENCE
OF IMPORTANT
OPERATING
AND
MAINTENANCE
(SER-
VICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING
THE APPLIANCE.
KT-7020(ir})
3
Advertisement
Table of Contents
