Advertisement
DISASSEMBLY FOR REPAIR
DISASSEMBLY FOR REPAIR
3. Removing the Pickup (Japan made)
1. Turn over the mechanism and short the short land of
the pickup (@).
2. Disconnect the two connectors (@).
5. When removing the tray, detach it in the direction of
arrow {@) in which it can be detached without the
sub panel caught by the tray stopper.
2-1. When the power is not turned on or when the
tray does not come out even by pressing the
OPEN key
1, Push the lever by a screwdriver, etc. put in througha
slit on the bottom plate of the product as shown on
the right ( @).
2. Thereby, the gear will be free with the tray slightly
advanced. Thus, draw out the tray towards you ( @).
Otherwise, as previously stated in step 3. of "2.
Removing the tray', push the tray towards you and
draw out the tray.
3. Remove the two screws (@), then remove the MD
assembly.
f2)
3. Installing the tray
. Set to location ( @) the protrusion on the upper side
of the gear as shown on the right.
2. Push in the tray along the left and right guides.
as
4. Remove the snap ring, then remove the gear (@ ).
5. Remove the stopper (@).
6. Remove the pickup in the direction of the arrow(@).
Note : When installing the pickup, in the reverse order
of disassembly.
Unsolder
the short land after connecting
the
connector.
Advertisement
