Table of Contents
Advertisement
POUR WATER WHEN FULL
When the water tank is full, the red light will flash and light up, and a beep
will sound to indicate that the water tank is full. Take out the water tank from
the back, open the water tank cover and pour out the water, place the water
tank cover on the water tank, then push it into the machine, and it will start
working immediately.
WATER TANK ADVANCEMENT REMINDER
FIGURE1
Please pay attention when re-pushing the water tank after taking it out.
There is a catch under the water tank of the fuselage to block the water tank
to prevent the water tank from sliding out when the fuselage is tilted.
Therefore, when re-pushing the water tank, please place the water tank
cover and push it in the direction of Figure 1. . You will feel resistance when
pushing to the position in Figure 2, please push hard to the position in Figure
3. (If the water tank is not pushed to the position shown in Figure 3, the
dehumidifier will not be able to start)
WATER TANK CAP REMINDER
When cleaning the water tank, the movable floating plate of the
water tank cover cannot be removed to avoid damaging the
machine's automatic shutdown function when full of water.
If the floating plate of the water tank cover is removed, it will
not be able to recognize when the water is full and it will
automatically shut down, causing the water to overflow and
cause the floor or table to get wet.
FIGURE2
FIGURE3
Advertisement
Table of Contents
