Safety Regulations - EINHELL GC-SA 1231/1 Original Operating Instructions

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Description of the warning logos (see Fig. 18)
A = Important!
Read the directions for use before operating
the
tool.
B = Keep other persons (and animals) away from
the danger zone.
C = Caution, sharp teeth. The teeth continue to
rotate after the equipment is switched off .
Pull the plug out of the socket outlet before
carrying out any maintenance or if the cable
becomes damaged.
D = Wear hearing and eye protection.
E = Keep the power cable away from the roller.
This equipment can be used by
children of 8 years and older and
by people with limited physical,
sensory or mental capacities or
those with no experience and
knowledge if they are supervised
or have received instruction in
how to use the equipment safe-
ly and understand the dangers
which result from such use.
Anl_GC_SA_1231_1_EX_UK_SPK7.indb 6 Anl_GC_SA_1231_1_EX_UK_SPK7.indb 6
GB
Children are not allowed to play
with the equipment. Unless su-
pervised, children are not allo-
wed to clean the equipment and
carry out user-level maintenance
work.
Replacing the power cable
If the power cable for this
equipment is damaged, it must
be replaced by the manufacturer
or its after-sales service or
similarly trained personnel to
avoid danger.
CAUTION: To prevent a risk
arising from the unintentional
resetting of the thermal cut out,
never connect the equipment
to an external switching device
such as a timer switch or to an
electric circuit which is regularly
switched on and off .
Both before and after every time the equipment
is used, check for damage and wear to the
mains connection and extension cable. The
equipment must not be used if cables are
damaged.
•
If the electricity supply should get damaged
during use of the equipment, the plug must
immediately be removed from the socket. The
mains connection and extension cable must
not be touched until the plug is removed from
the socket.
•
Before each use, check the equipment for
possible damage. The equipment should
not be used if it is damaged, and must not
be used up until it has been attended to by a
specialist/our customer service personnel.
•
If the equipment vibrates excessively, switch
it off immediately and remove the plug from
the socket. Tilt the equipment to examine
- 6 -
24.08.2023 10:54:10 24.08.2023 10:54:10