Delete Product Parameters; Calibration Scale - General Measure CW-6K User Manual

the parameter value will remain unchanged; if it is higher than the upper
limit of the parameter range, the upper limit of the parameter range will be
written by default.
 The definition of weight checking speed, belt speed and correction
coefficient is described in detail on the help interface of product
parameters. If necessary, you can click "Help" to view.

3.5.4 Delete product parameters

On the product list page, select the product to be deleted and click "Delete
Product" to delete the product. After deleting the product, the following product
parameters will move forward in order, and the product number will move
forward.The product cannot be deleted during the operation of the weight check
scale;In order to prevent product parameters from being incorrectly deleted, the
product name should be set reasonably when setting product parameters.

Calibration scale

3.6
In order to ensure the correct weight of the weighing scale and the linearity of the
weight change, each weighing scale needs to carry out weight calibration and dynamic
calibration.For specific operation methods, please refer to "Operation Instructions
on Buttons and Operation Frames" in section 3.3.2.
Figure 3-11 shows an example of the weight calibration interface
Description of static calibration parameters:
21
CW-6K user's manual