Adjusting The Sound With The Graphic - Sony XE-744 Operating Instructions Manual

Adjusting the Sound With the Graphic |
Equalizer
FEWN
Press the EO button to select the speakers from which you wish the processed
sound to come out. (See page 7.)
If the egualizer output is switched off, the following procedure do not change the tonal
guality of the sound.
a
Press the MEM button.
The unit enters the equalizer sound-curve set mode.
(EN
(The display changes to that of the
equalizer sound-curve and starts flashing.)
While the equalizer sound-curve is flashing, press the frequency select button
whose frequency you wish to adjust.
For example, when you have pressed
the ($) button
(The indication of the frequency which you
have selected stops flashing.)
To adjust more than two freguencies While adjusting, the EQ, SUB W and FAD buttons
simultaneously for the same amount function normally
While the equalizer sound-curve is flashing, press the To adjust the € n more precisely, press the
buttons whose assigned freguencies you wish to respective button:
adjust. The corresponding segments start flashing,
then press either side of the +/- button to adjust the
levels.