Erasing A Single Track; If You Record Without First Inserting A Disk; Playback - Yamaha Clavinova CLP-156 Owner's Manual

Using the Recorder

Erasing a Single Track

If You Record Without First
Inserting a Disk ...
cpY
MIDI/
TRANSPOSE r
c 3
TEMPO
PLAY
PLAY
20
All data can be erased from either of the recorder's tracks by engaging the
record mode, selecting the track you want to erase, and then pressing the
[PLAY] button twice without recording any data.
If you forget to insert a properly formatted floppy disk before recording, it is
possible to record up to approximately 600 notes before the 8-kilobyte internal
memory becomes full. If you want to keep this data, it is possible to copy it to
disk by following the procedure outlined below.
CAUTION
c__
Z
While holding the [MIDI/TRANSPOSE] button, press either the SONG
SONG
[r] and [f] button several times until "cPy" appears on the display.
f
Release the [MIDI/TRANSPOSE] button when "c_ _" appears on the
display.
X
Use the TEMPO [ ] or [ ] button to select the song number to which
you want to copy the data.
C
Insert the disk you want to copy the data to.
V
Press the [PLAY] button. If no previous data exists in the specified song
number "cPy" will appear on the display and the data in the CLP-156
memory will be copied to the disk. If the specified song number already
REC contains data, "n y" will appear on the display. In this case press the
TEMPO [ ] button (yes) if you want to go ahead with the copy operation,
thereby erasing the previous data, or the TEMPO [ ] button (no) if you
want to cancel the copy operation and leave the existing data intact. In the
latter case repeat the procedure, selecting an empty song number.
To play back what you've recorded, simply press the RECORDER [PLAY]
REC
button. Playback starts from the beginning of the recorded data, and will stop
automatically at the end of the recorded data. You can also stop playback at
any time by pressing the [PLAY] button. To mute a track so that it doesn't play
back, press the corresponding track button so that its indicator goes out.
Also refer to the "Disk Playback" section (page 16) for other playback func-
tions.
• Any of the following operations will erase all data in the internal memory. Be
sure to copy the data in memory to disk before:
1: Turning the power switch OFF.
2: Loading a PianoSoft disk (including the supplied disk).
3: Inserting any disk and selecting a song number.

Playback

• If the metronome is being used during playback, the metronome will stop
NOTE
when playback is stopped.
• The playback data is not transmitted via the MIDI OUT terminal.