McIntosh MT5 Owner's Manual page 10

Assembling the Turntable (continued)
Center of Position
Marking
Figure 18
13. Remove the protective film material from the
Tone Arm Rest Position. Refer to figures 19
and 20.
Protective
Film
Figure 19
Tone Arm
Rest
Figure 20
10
Note: If another Phono Cartridge (such as the
McIntosh MCC10) is to be used with the MT5 turnta-
ble, proceed to page 10 "Installing a non-supplied
Cartridge" at this time.
14. Carefully slide off the Stylus Guard from the
cartridge by pulling the cover straight down.
Refer to figures 21 and 22.
Cartridge
Figure 21
Figure 22
Note: The Tracking Force, Anti-Skating and other adjust-
ments have been preset at the factory for optimum
performance. For additional information on setting
Tracking Force, Anti-Skating and other adjustments
refer to pages 11 thru 13.
15. Using the supplied Tracking Force Scale,
set the force to 1.8 - 2.2 gm for the Sumiko
Amethyst Cartridge.
16. Proceed to "How to Connect the Turntable"
on page 15.
Stylus
Guard