Table of Contents
Advertisement
Available languages
Available languages
1.
Place the Quick Install Guide on the wall in the desired location to determine the spacing
and placement of the mounting holes on the wall. A carpenters level should be used to
insure that the O3 Pure LS is mounted level in the horizontal plane. (Fig. c)
2.
Mark the location of the two mounting holes on the wall with a pencil. Drill appropriate
sized holes for the screws or mollies in each marked location. Install the screws leaving
them protruding from the wall by about 1/4 inch. A set of mounting hardware has been
provided. If it is not possible to mount the O3 Pure LS to wall studs, you should use
the included "molly" type expandable screw anchors. For any other type of mounting
scenario (concrete block, etc.) please consult your local hardware store for assistance.
3.
If needed remove the cover from your O3 Pure LS by slightly pressing the tabs on each
side of the cover inwards. (Fig. d - d.1) While gently holding the tabs in, lift the cover up
1 inch and then straight out toward you. There is a quick disconnect for the Ozone
Level Button. It is located behind the cover and can be used to set the cover down for
easier installation.
4.
Place the O3 Pure LS against the wall so that the protruding screws slip through the
"keyholes" (Fig. e - e.1) in the back of the unit. Slide the unit down into the lock position
of the keyholes. You can now tighten the two screws to hold the unit firmly in place. DO
NOT over tighten the screws.
5.
Turn off the cold water taps/faucet to your washing machine. Place a pail under the
cold water hose connection to the washing machine. Disconnect the cold hose from
the washing machine placing the end into the pail. Flush cold water line with water
by turning the cold water tap on. Check filter (if applicable) at the cold water inlet of
washing machine. Clean residue from filter if necessary. Check that the rubber washers
in the hoses is in place and connect the cold water hose from the cold water supply
to the inlet supply of the O3 Pure LS (Fig. f - f.2). Properly tighten the hose to the inlet
fitting, but do not over tighten and do not use thread tape.
6.
Using the new hose provided, connect one end of the hose to the water outlet of the O3
Pure LS and the other end of the hose to the cold water inlet of the washing machine
(Fig. f - f.1) Properly tighten both ends of the hose, but do not over tighten or use thread
tape.
7.
Replace the cover on the O3 Pure LS.
8.
Plug the power adapter into the DC adapter plug-in on the side of the O3 Pure LS unit
(d.2) and then plug the adopter into the wall outlet. (Fig. b)
9.
Ensure all hoses are properly installed and tightened, and that the power supply has
been securely plugged in. SLOWLY turn the COLD water supply back on and check for
any leaks or drips. Gently retighten the fittings and if leaks are apparent, be careful not
to over tighten.
10. Set the wash cycle on your washing machine to COLD WATER wash and COLD
WATER rinse.
Page 3
Installation:
Advertisement
Table of Contents
