Related Manuals for Heatwave Sirona Hemlock SA7008
Summary of Contents for Heatwave Sirona Hemlock SA7008
- Page 1 OWNER’S MANUAL Sirona Hemlock Infrared Suana SA7009 4-Person with 9 Carbon Heaters SA7008 3-Person with 8 Carbon Heaters SA7008/SA7009 Rev. 11/23...
-
Page 2: Table Of Contents
TABLE OF CONTENTS ASSEMBLY TIPS & WARNINGS HEALTH & SAFETY WARNINGS PARTS IDENTIFIER REPLACEMENT PARTS 5, 6, 8 PARTS SCHEMATIC 7, 9 SAUNA ASSEMBLY INSTRUCTIONS 10-16 BACKREST ASSEMBLY INSTRUCTIONS CONTROL PANEL INSTRUCTIONS 18-19 TROUBLESHOOTING GUIDE 20-21 SAUNA USE DISCLAIMER ENJOYING YOUR SAUNA CLEANING AND MAINTENANCE WARRANTY 23-24... -
Page 3: Assembly Tips & Warnings
ASSEMBLY TIPS & WARNINGS • Before you begin, read all assembly instructions and safety warnings carefully. • This sauna requires at least 2 adults to complete assembly. • Remove all of the contents from the boxes and verify that you have all of the parts shown on the Parts Identifier (Page 5) before you begin assembly. -
Page 4: Health & Safety Warnings
HEALTH & SAFETY WARNINGS 1. Review all instructions and warnings before operating your sauna. A sauna is not a toy. Serious injury may result from negligence, intentional misuse, and failure to follow safety instructions. 2. Hyperthermia Danger: Hyperthermia occurs when the body absorbs more heat than it can dissipate. -
Page 5: Parts Identifier
PARTS IDENTIFIER (NOT TO SCALE) TOUCH SCREEN CONTROL PANEL REPLACEMENT PARTS The following page lists part numbers specific to your particular sauna model. In the event that you need replacement parts, use this guide to reference the part number. It is important to use only replacement parts specified by the manufacturer. - Page 6 REPLACEMENT PARTS (CONT.) SA7008 3-PERSON SAUNA WITH 8 CARBON HEATERS REF. # DESCRIPTION PART # QTY. FRONT GLASS DOOR SAP7023 RIGHT SIDE PANEL SAP7024 FRONT RIGHT PANEL SAP7025 BACK PANEL SAP7026 LEFT SIDE PANEL SAP7027 ROOF SAP70554 ROOF COVER SAP7029 FLOOR SAP70301 FLOOR HEATER COVER...
-
Page 7: Parts Schematic
PARTS SCHEMATIC SA7008 This drawing is for illustrative purposes only. It will not match your sauna exactly, but will indicate location of similar parts. Illustrations are not to scale. - Page 8 REPLACEMENT PARTS (CONT.) SA7009 4-PERSON SAUNA WITH 8 CARBON HEATERS REF. # DESCRIPTION PART # QTY. FRONT GLASS DOOR SAP7023 RIGHT SIDE PANEL SAP7045 FRONT RIGHT PANEL SAP7046 BACK PANEL SAP7047 LEFT SIDE PANEL SAP7048 ROOF SAP70555 ROOF COVER SAP7050 FLOOR SAP70511 FLOOR HEATER COVER...
- Page 9 PARTS SCHEMATIC SA7009 This drawing is for illustrative purposes only. It will not match your sauna exactly, but will indicate location of similar parts. Illustrations are not to scale.
-
Page 10: Sauna Assembly Instructions
SAUNA ASSEMBLY INSTRUCTIONS 1. Begin assembly by determining an appropriate location for your sauna - see ASSEMBLY TIPS & WARNINGS (Page 3) for details. Place the FLOOR PANEL on the floor in this location. NOTE: On your model, the FLOOR HEATER is now pre-installed in the floor (NOT SHOWN) 2. - Page 11 SAUNA ASSEMBLY INSTRUCTIONS (CONT.) 4. Place the BACK WALL PANEL on the FLOOR against the floor trim, as shown, and make sure it fits snugly against the RIGHT SIDE WALL PANEL with the trim overlapping the wall, then engage buckles from bottom to top.
- Page 12 SAUNA ASSEMBLY INSTRUCTIONS (CONT.) 7. Connect the black floor heater plug and the bench heater plug into the black plugs from the front BACK WALL PANEL. 8. Connect the white MOOD LIGHTING bench plugs. Make sure they click together tightly. Place the BENCH SEAT on the BACK WALL PANEL.
- Page 13 SAUNA ASSEMBLY INSTRUCTIONS (CONT.) 10A. Once the ROOF is in place, use two 1-1/2” (40mm) SCREWS to secure the roof to the back wall in the marked holes as shown below. 10B. Secure the ROOF and the FLOOR, from the interior, with four 1-1/2” (40mm) SCREWS using the pre-drilled holes located inside, two at the top and two at the bottom (hole locations are indicated by the arrows below).
- Page 14 SAUNA ASSEMBLY INSTRUCTIONS (CONT.) 11. Attach the DOOR HANDLE to the GLASS DOOR by using two 1-1/2” (40mm) SCREWS as shown. 12A. Slide the SIDE WALL GLASS into the slot on the LEFT SIDE WALL and the FLOOR. Attach to the FLOOR using one 3/4”...
- Page 15 SAUNA ASSEMBLY INSTRUCTIONS (CONT.) 13A. Connect the heater cable plugs, control panel wires, and mood lighting on the roof to the corresponding wire connections coming up through the walls and the control panel roof hole. Make sure all wires are connected tightly. 13B.
- Page 16 SAUNA ASSEMBLY INSTRUCTIONS (CONT.) 14. Remove the back cover of the OXYGEN IONIZER. Unwrap and install the fragrance patch, then reattach the back cover. Attach the OXYGEN IONIZER in the designated position with two 5/8” (16mm) SCREWS. Plug the power cable into the OXYGEN IONIZER. 15.
-
Page 17: Backrest Assembly Instructions
SA7008/SA7009 BACKREST - SAP2818 ASSEMBLY INSTRUCTIONS Images not to scale *Items included in Hardware Pack, SAP7019 NOTE: Two 2 3/4” (70 mm) screws are included with the sauna in a separate bag for the installation of the control panel. These replace the 2” screws indicated in the manual. For replacement parts, please call our Consumer Hotline at 1-800-759-0977. -
Page 18: Control Panel Instructions
CONTROL PANEL INSTRUCTIONS 1. Press and hold the screen for five seconds to power on the control panel. 2. Refer to the following diagram below for the main menu options: Sauna temperature, timer, & color therapy light Sauna temperature Color therapy and &... - Page 19 CONTROL PANEL INSTRUCTIONS (CONT.) 3. Press the sauna icon. Use the plus or minus buttons or the slide bar to adjust the temperature and the timer. Turn the reading light and chromotherapy light on and off with the toggle buttons. Select a color for the chromotherapy light from the options shown 4.
-
Page 20: Troubleshooting Guide
TROUBLESHOOTING GUIDE WARNING! • Always unplug the sauna and allow it to cool down before performing any maintenance. • Repairs to the electrical components of the sauna should only be performed by a qualified service technician. • Unauthorized repairs or alterations will void the manufacturer’s warranty. PROBLEM THERE IS NO POWER TO THE SAUNA 1. -
Page 21: Sauna Use Disclaimer
TROUBLESHOOTING GUIDE (CONT.) PROBLEM THE SPEAKERS ARE NOT WORKING 1. Check that the volume is not turned all the way down and that the fader control is set correctly. 2. If only one speaker is working, check to see that the sound balance on the Solution stereo is not set all the way to one side. -
Page 22: Enjoying Your Sauna
ENJOYING YOUR SAUNA 1. Prior to initial use, wipe down all interior surfaces of the sauna with a damp cloth. 2. Turn on the sauna and set the temperature to 104ºF for one hour to burn off any factory dust. 3. -
Page 23: Warranty
SAUNA WARRANTY REGISTRATION CARD 1. This sauna has a 7-Year Limited Warranty against defects in material and workmanship from date of purchase. To receive the warranty, the card below must be completely filled out and returned within 30 days from the date of purchase. - Page 24 SAUNA WARRANTY REGISTRATION CARD (CONT.) To send in this warranty card, fill it out, detach it, and mail it to the following address: ATTN: Heatwave Sauna Warranty Blue Wave Products 101 N. Raddant Rd. Batavia, IL 60510 For further warranty information or inquiries, please call our Consumer Hotline 1-800-759-0977 or email at warranty@bluewaveproducts.com.
Need help?
Do you have a question about the Sirona Hemlock SA7008 and is the answer not in the manual?
Questions and answers