Routing and Connecting the Wire
Harness to the Engine
1.
Rout the branch of the wire harness with the ring
terminal and the 2-socket connector toward the
front of the engine.
2.
Assemble the ring terminal of the wire harness
to the engine
(Figure
bolt that you removed in
Harness from the Chassis (page
Figure 23
1. Engine
2. Ring terminal (machine
wire harness)
3.
Insert the 2-pin connector of the voltage-regulator
harness into the 2-socket connector for the
machine wire harness
Figure 24
1. 2-pin connector
(voltage-regulator
harness)
23) with the flange-head
Removing the Wire
6).
3. Flange-head bolt
(Figure
24).
2. 2-socket (machine wire
harness)
4
Installing the Transmission
Return and Neutral Arms
Parts needed for this procedure:
1
Torx-head screw
1
Lower return arm
1
Upper return arm
1
Neutral arm and reverse switch
Removing the Bidirectional and
Return-Control Arms
1.
Remove the flange locknut and carriage bolt that
secure the transaxle bracket to the return-control
arm
(Figure
g289268
g289140
1. Flange locknut
2. Transaxle bracket
11
25).
Figure 25
3. Carriage bolt
g289448
g289452