Advertisement
A - LCD Function Screen – Displays Level, Voicing Modes, EQ, and System Settings
(Note: The LCD screen will automatically turn off after 5 minutes of non-use to
preserve the life of the LCD; it will re-illuminate with the press of the function knob)
B - Analog Input – Balanced XLR / ¼" balanced TRS or unbalanced TS phone jack
C - Power On / Off Switch
D - Function Knob – Rotate and push to access functions and adjust parameters
E - IEC320 C14 AC Inlet
F – 5x20 mm Fuse Holder (Fuse rating printed below holder)
here). From the Home Screen, rotate the FUNCTION knob to raise or lower the level
or press the FUNCTION knob to access EQ, SETUP, and more.
LEVEL is set at the factory to 0 dB (+4 dBu input sensitivity). Increase/decrease this
equally on both monitors in 0.1 dB steps to set the volume to your desired level or
to match these to other monitors in your studio.
From the MENU screen, select EQ to access the EQ settings.
Voicing Modes can be changed by pressing the function knob to switch between
the modes.
Mix Mode – Flat frequency and phase response best used for mixing, mastering,
and critical listening.
Create Mode – Inspirational voicing that is best used for writing, producing, and
casual listening.
Focus Mode – Mid-focused voicing for a critical analysis of the midrange band.
Turn the function knob and press to select Low EQ. Turn the function knob to scroll
to the desired Low EQ setting and press to select.
you need more low frequency content; set these to your taste.
The HOME SCREEN is visible when the monitor is
powered on and it finishes the boot sequence. As a quick
overview of the system, a visual indication of the Level,
Voicing Mode, and EQ setting is shown (MIX Mode shown
L. SHELF Cut (-dB) settings are boundary condition filters.
These EQ settings roll off the additional low-end that
becomes present when the monitors are set close to walls
or other large hard surface boundaries.
L. SHELF Boost (+dB) setting will add additional low-end if
Advertisement
