Masimo stork Replacement Sensor User Manual

Replacement Sensor
U S E R ' S M A N U A L
Not intended for use as a medical device or to replace a medical device. Do not use it to
diagnose, cure, treat, alleviate, or prevent any disease or health condition.
Download the Stork App before using this product. For help, go to www.masimostork.com for
additional tips and tutorials, a full list of supported devices, warranty, trouble shooting, and
customer support. Follow the in app instructions for device pairing and general set up.
DESCRIPTION
Stork™ is a smart home baby monitoring system designed for parents to monitor
a healthy baby at home. The Stork Sensor
the bottom of the Stork Boot. It uses Masimo SET
health data, including oxygen saturation, pulse rate, and temperature. It is also
capable of determining baby's position and notifying you in-app if baby is face
up or face down.
Use as a Stork replacement sensor or as an extra sensor that will allow you to
continuously track your baby's health data without charging downtime.
Contents:
A. B.
Stork Sensor Magnetic Charge Cable & Cord Clip
Not included: Boot, Boot Straps, Camera, or Hub (all sold separately).
INSTRUCTIONS
a) Charge the sensor
CAUTION: Make sure the sensor is fully changed before use.
1. Refer to Fig. 1. Plug in the USB-C cable to the 5W power adapter.
2. Refer to Fig. 2. Plug in the power adapter into a wall socket.
5W 5W
3. Refer to Fig. 3. Peel and stick the cord clip to secure the sensor charge cord.
4. Refer to Fig. 4. Connect the magnetic charger to the sensor.
3.
5. Refer to Fig. 5. The sensor is fully changed when the LED light turns solid
white.
b) Pair the Sensor with your device
1. Refer to Fig. 6. Open the Stork App
2. Follow the on screen instructions to pair the sensor.
is a wireless sensor that fits into
technology to track baby's
®
C.
5
W Power Adapter
1.
5.
solid white light
(phone not included)
and click on Sensor.
6.
en
c) Insert the Sensor into the Boot
1. Refer to Fig.
the Masimo logo facing down and press down to secure the sensor. The
sensor should sit flush in the boot.
2. Refer to Fig.
boot and/or in the app to ensure the boot fits properly and the straps are
not too tight to avoid injury.
Too long
d) Remove the Sensor
1. Refer to Fig.
the boot to remove the sensor from the boot.
CLEANING
2.
CAUTION:
• Do not use undiluted bleach or any cleaning solution other than those recommended
here because permanent damage to the sensor could occur.
• Do not immerse the connector of the sensor or cable in any liquid solution.
• Using excessive force when removing the saensor may damage it.
To clean the sensor
1. Remove the sensor from the baby and the
boot.
2. Refer to Fig.
it with a 70% isopropyl alcohol pad or mild
4.
detergent.
3. Allow the sensor to dry completely prior to
charging or use.
CUSTOMER SUPPORT
For product support, along with troubleshooting for your
please go to the
www.masimostork.com/en-us/support/contact-us.html
Replacement
Masimo Corporation
52 Discovery
Irvine, CA 92618
USA
www.masimostork.com
© 2023 Masimo Corporation
7. Insert the sensor into the boot at an angle, toe end first, with
8. WARNING: Follow the instructions from your
PERFECT
9.
Gently push the sensor through the opening on bottom of
10. Clean the sensor by wiping
Stork support page:
Sensor
Stork system,
Too short
Stork product,
304175/11839A-0623