Meter Use And Precautions - Smart Meter iGlucose Essential User Manual

Notes:
Your iGlucose®Essential Meter is preset with beep sound function, the
meter will beep when:
Turning on the meter.
When setting the date and time (in set-up mode).
When the test strip is inserted and ready for application of blood or
control solution.
When su cient blood or control solution is pulled into the test strip.
When the test is complete.
If any error occurs during operation.

Meter Use and Precautions

The meter displays blood glucose concentration in milligrams per
deciliter (mg/dL) only.
The meter will shut o by itself after 2 minutes of inactivity.
Refer to the Cleaning and Disinfection section to keep the entire
meter clean. Keep your meter in the temperature range 41-113°F and
relative humidity range 10-90%. Do not leave it in your car.
Do not drop the meter or get it wet. If you do drop the meter or get it
wet, check the meter by running a quality control test. Refer to Testing
with Control Solution for instructions.
Do not use the meter if it drops into water or other liquids or water
has splashed on it..
You should use the meter only as described in this user manual. Any
use of the meter beyond the scope of instructions in this user manual
may impair the normal operation of the meter and battery.
Do not transfer the test strips to a new vial or any other container.
Do not drop the blood on the test strip. The blood is pulled into the
tip of the test strip through capillary action:
The low glucose test result may indicate hypoglycemia.
Signal strength.
Center area on the display that shows test results or
error codes.
Indicates the temperature is not suitable for testing.
Test results are displayed as mg/dL.
When strip is inserted, the drop will ash, indicating the system
is ready to test.
Pre-meal marker.
Post-meal marker.
Control test result.
3