Advertisement
ATTENTION
To avoid the possibility of malfunction/damage to the product, damage to data, or damage
to other property, please follow the points as below.
Operation and maintenance
•
Do not use the device in the vicinity of a TV, radio, stereo equipment, mobile phone, or
other electric devices. Otherwise, the device, TV, or radio may generate noise.
•
In order to prevent the possibility of panel dis guration, unstable operation, or damage to
the internal components. Do not expose the device to excessive dust or vibration, or
extreme cold or heat (such as in direct sunlight, near a heater, or in a car during the day).
•
Do not place vinyl, plastic or rubber objects on the device, since this might discolor the panel.
•
When cleaning the device, use a dry and soft cloth. Do not use paint thinners, solvents,
cleaning uids, or chemical impregnated wiping cloths.
•
Condensation can occur in the device due to rapid, drastic changes in ambient temperature
when the device is moved from one location to another, or air conditioner is turned on or o .
For example, using the device while condensation is present can cause damage. If there is
reason to believe that condensation might have occurred, leave the device for several hours
without turning on the power until the condensation has completely dried out.
•
Avoid setting all controls to their maximum. Depending on the condition of the connected
devices, doing so may cause feedback and may damage the speakers.
•
When turning on the power in your audio system, always turn on the power ampli er LAST,
to avoid speaker damage. When turning the power o , the power ampli er should be turned
o FIRST for the same reason.
Precautions when using the USB 2.0 and 5V DC terminals
When connecting the USB2.0 connector to computer, please must abide by following points.
If not, it may cause computer crash, breakdown, or losing data. If the computer or unit crash,
please restart the application software or computer operating system, or disconnect the unit,
then power on again.
•
Use an AB type USB cable. USB 3.0 cable cannot be used.
•
Before connecting the computer to the USB 2.0 terminal, exit from any power-saving mode
of the computer (such as suspend, sleep, standby).
2
www.PyleUSA.com
CONNECTION DIAGRAM
For MIC & GUITAR inputs
MIC INPUT
GUITAR INPUT
ST
ST
MONO
MONO
*Keep the buttons bounce
up, for STEREO inputs.
*Press down the buttons,
for MONO inputs.
Stereo
Transfer
and
Record
Power Bank
PC USB Power Supply
L
R
L R
Power Supply:DC 5V,1A
Power Socket
Active Speakers
www.PyleUSA.com
3
Advertisement
