Playing A Dvd - Yamaha YHT-700 Quick Connect Manual

O T U
PERATING HE NIVERSAL
O
VERVIEW
The universal remote control will control up to nine
different types of components each of which becomes
active when you press a selection ( except TV which
has priority and TV function buttons are always active).
We can only briefly describe some functions here, and
we encourage you use the HTR-5550 Owner's Manual
to gain additional experience with this powerful unit.
P A V
LAYING IDEOCASSETTE
1. Aim the remote control at the HTR-5550, press
SYSTEM POWER to turn the receiver on. Press
VCR as the input for the receiver.
2. Aim the remote control at the TV, press the TV
POWER to turn the television on.
3. Aim the remote control at the VCR, press VCR to
select the component, and then press AV POWER
to turn the VCR on. Put a tape in the VCR, press
(forward button) to start play.
NOTE: At this point, the VCR controls are assigned to
the remote control, since VCR was the last selected
component.
P A DVD
LAYING
1. Aim the remote control at the HTR-5550, press
SYSTEM POWER to turn the receiver on.
Press DVD as the input for the receiver.
2. Press DVD and then press AV POWER to turn the
DVD player on.
NOTE: If the DVD player is plugged into the switched
outlet (on the back of the receiver) and its power switch AC
was already engaged, the unit will come on each time the
receiver is powered on.
12
R C
EMOTE ONTROL
©2002 YAMAHA ELECTRONICS CORPORATION, USA
6660 Orangethorpe Avenue, Buena Park, CA 90620
PH: (714) 522-9105; FAX: (888) 435-7922
http://www.yamaha.com
YHT-700 Q
U I C K
3. Load a DVD into the DVD player.
4. Aim the remote control at the DVD player, and press
(forward button) to start play.
NOTE: The DVD player's controls are now assigned to
the remote control buttons, since DVD was the last
selected component.
R T R
ESETTING HE EMOTE
You can reset the remote control to factory codes for
all components or a desired component, as follows:
R C F A
ESETTING ODES OR
1. Press any component selector.
2. Press CODE SET using a ballpoint pen or similar
object. The TRANSMIT indicator LED will flash twice.
3. Using the keypad, enter the code "9990".
4. The indicator LED will flash twice to confirm all
codes have been reset to factory values. If the LED
does not flash twice, repeat steps 1 through 3.
R C F A D
ESETTING ODES OR
1. Press a component selector button that matches the
component you wish to reset to factory codes.
2. Press CODE SET. The TRANSMIT indicator LED
will flash twice.
3. Using the keypad, enter the code "0000".
4. The indicator LED will flash twice to confirm all
codes have been reset to factory values. If the LED
does not flash twice, repeat steps 1 through 3.
5. For your convenience, the following reference chart
lists the factory codes:
Component
Selector Button
CD
MD/CD-R
TUNER
DVD
-C
O N N E C T
C T F C
ONTROL O ACTORY
C
LL OMPONENTS
C
ESIRED OMPONENT
Component Code
CD 0005 Yamaha
MD 0024 Yamaha
TUNER 0003 Yamaha
DVD 0098 Yamaha
G
U I D E
ODES