Setting The Clock; Adjusting Brightness Of The Display - Yamaha GX-505VCD Owner's Manual

Preparations and connections

Setting the clock

1 2
DISC DISC
3–DISC VCD CHANGER
STANDBY
STANDBY
/ON
TIMER
PRESET/TUNING/BAND A/B/C/D/E
INPUT
BASS TREBLE
REC/
PHONES
MODE DOLBY NR PAUSE
DIRECTION
AUTO REVERSE CASSETTE DECK DOLBY B NR
DISPLAY
1
2
MEMORY RANDOM REPEAT
TIME ADJ HOUR MIN
3
MEMORY RANDOM REPEAT
TIME ADJ HOUR MIN

Adjusting brightness of the display

DISC CHANGE OPEN/CLOSE
VIDEO CD
DIGITAL VIDEO
Version 2.0 / Playback Control
YMERSION B.BOOST
VOLUME
UP
DOWN
Y RANDOM REPEAT TIME DISPLAY
HOUR MIN
-8
E
3
DISC DISC CHANGE OPEN/CLOSE
VIDEO CD
DIGITAL VIDEO
Version 2.0 / Playback Control
YMERSION B.BOOST MUSIC
VOLUME
/
UP
DOWN
AUTO/
MANUAL MEMORY RANDOM REPEAT TIME DISPLAY
TIMER TIME ADJ HOUR MIN
KARAOKE
MIC MIXING
1 MIC 2
OPEN/CLOSE
MIN MAX
Changes.
Changes.
MUSIC
VOLUME
DISPLAY
1
While the power is on, press DISPLAY to display time.
2
While holding down TIME ADJ, press HOUR and set the hour.
* Press HOUR once to advance the time by 1 hour. Press and
hold to advance continuously.
3
While holding down TIME ADJ, press MIN and set the minute.
* Press MIN once to advance the time by 1 minute. Press and
hold to advance continuously.
* The hour setting will not advance even if minute is advanced
from "59" to "00".
Singapore model uses a 24-hour display. For China and
General models, either the 24-hour display or the 12-hour
display [shown by "AM (PM) 12:00"] is selected depending on
the setting of the FREQUENCY STEP switch on the rear
panel.
* Set this system into the standby mode and disconnect the AC supply
lead when switching the FREQUENCY STEP.
Note
In the event of a power failure or when the AC supply lead is disconnected,
the time display will go out; however, the clock will function for about 5
minutes without any power supply. Otherwise, the time display will flash
on and off to indicate that time must be reset.
If desired, you can adjust the brightness of the display.
Press and hold DISPLAY for more than 2 seconds so that
"DIMMER ±0" appears on the display.
While holding down DISPLAY, turn VOLUME clockwise to
increase or counterclockwise to decrease brightness.
Control range: ±0 to –6 (Preset value: ±0)