Setting The Clock; Adjusting Brightness Of The Display - Yamaha GX-900RDS Owner's Manual

Setting the clock

3–DISC CD CHANGER
STANDBY TIMER
BASS TREBLE
PHONES
AUTO REVERSE CASSETTE DECK
DOLBY B NR
1
DISPLAY
2
FREQ PS/PTY/RT/CT
MODE – PTY
RANDOM REPEAT MEMORY
HOUR MIN
FREQ PS/PTY/RT/CT
MODE – PTY
RANDOM REPEAT MEMORY
HOUR MIN

Adjusting brightness of the display

1 2
DISC DISC DISC
PTY SELECT
YMERSION B.BOOST MUSIC
CHARACTER SET MD
REC/PAUSE
MODE DOLBY NR
TAPE
1 2 3
DISC DISC DISC DISC CHANGE OPEN / CLOSE
PTY SELECT PRESET/ TUNING/ BAND A/B/C/D/E
VOLUME
DOWN UP
YMERSION B.BOOST MUSIC INPUT INPUT
FREQ PS/PTY/RT/CT MODE–PTY SEEK– START
CHARACTER SET MD RANDOM REPEAT TIME
HOUR MIN
REC/PAUSE
MODE DOLBY NR AUTO/MANUAL MEMORY DISPLAY
TAPE TIMER TIME ADJ
STANDBY/ON
TAPE MD
MINIDISC RECORDER
MD EDIT DELETE PAUSE/ENTER
DIRECTION
TIME ADJ
Changes.
TIME ADJ
Changes.
3
DISC CHANGE OPEN / CLOSE
PRESET/ TUNING/ BAND A/B/C/D/E
VOLUME
DOWN UP
VOLUME
INPUT INPUT
FREQ PS/PTY/RT/CT
MODE–PTY SEEK– START
RANDOM REPEAT TIME
HOUR MIN
AUTO/MANUAL MEMORY DISPLAY
DISPLAY
TIMER TIME ADJ
STANDBY/ON
Preparations and connections
1
While the power is on, press DISPLAY to display the time.
2
While holding TIME ADJ pressed, press HOUR and set the
hour.
* Press HOUR once to advance the time by 1 hour. Press
and hold to advance continuously.
3
While holding TIME ADJ pressed, press MIN and set the
minute.
* Press MIN once to advance the time by 1
minute. Press and hold to advance continuously.
* The hour setting will not advance even if minute is
advanced from "59" to "00".
Note
In the event of a power failure or when the AC supply lead is
disconnected, the time display will go out, however, the clock
will function for about 5 minutes without any power supply.
Otherwise, the time display will flash on and off to indicate that
the time must be reset.
If desired, you can adjust the brightness of the display.
Press and hold DISPLAY for more than 2 seconds so that
"DIMMER ±0" appears on the display.
While holding DISPLAY pressed, turn VOLUME clockwise to
increase or counterclockwise to decrease brightness.
Control range: ±0 to –6 (Preset value: ±0)
E-7