Hitachi CIS02-H Installation & Maintenance Manual page 10

2. Installation Work
[Installation Procedures]
(1) Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and turn
the slotted screwdriver to separate and remove the controller from the holding bracket.
NOTE:
•
Do not insert the slotted screwdriver into the tab part beside the groove. The tab may be damaged and the eco
compact wired remote controller cannot be installed.
7
Groove Part
Holding Bracket
上 上
Tabs for Attaching Controller
Approx. 1/4 inches(6mm)
Slotted
Screwdriver
Figure Seen from Bottom Side