Wiring - Yamaha P2500S Owner's Manual

I Wiring
5-way binding post
(1) Turn off the POWER switch.
(2) Remove the cover attachment screws and remove the pro-
tective cover from the speaker terminals.
(3) Remove about 15 mm of insulation from the end of each
speaker cable, and pass the bare wire through the holes in
the appropriate speaker terminals. Tighten the terminals to
securely clamp the wires. Refer to page 9 for speaker
polarities.
*
Speaker cable
Note to users in the USA:
Please use Class 3 wiring. (P7000S, P5000S)
Please use Class 2 wiring. (P3500S, P2500S)
Be sure that the bare wire ends do not jut out from the ter-
minals and touch the chassis. The following shows how
the cable should look when correctly attached.
(4) Reattach the protective cover over the speaker terminals.
10
Screw
* Actual size
Bare wire
Chassis
Speakon connector
(1) Turn off the POWER switch.
(2) Insert the Neutrik NL4FC plugs into the Speakon connec-
tor on the rear of the amplifier, and turn clockwise to lock.
Neutrik NL4FC plugs
CHANNEL
STEREO or PARALLEL
1+
1–
2+
2–
Neutrik NL4FC plugs
CHANNEL
1+
1–
Phone jack
(1) Turn off the POWER switch.
(2) Insert the phone plug into the jack on the rear of the ampli-
fier.
A
BRIDGE
A+ 1+ +
A– 1–
B+ 2+ –
B– 2–
B
B+
B–