Table of Contents
Advertisement
Operating instructions
Broadcasting reception
Auto tuning (Almost all stations can be tuned in)
1. Press the POWER switch.
2. Press the AM switch for AM reception or the FM switch
for FM reception.
3. Set the AUTO/MANUAL switch to AUTO (unlatched.)
4. Set the FM MODE switch to STEREO (unlatched).
The muting will act in FM mode.
5. Press the UP (®) or DOWN
(4) switch to start the tuning
system
in the direction of the desired station.
Release
when
the frequency
display
shows
that you
are ap-
proaching your station.
The auto tuning will stop auto-
matically when the station is received, and the frequency
display will show the channel frequency.
Note, if the auto
tuning stops at an unwanted station before it reaches the
desired station, press the UP (®) or DOWN
(4) switch
again.
6. Adjust the VOLUME
CONTROL
to the desired listening
level.
:
7. Adjust the balance of the left and right channels.
8. Use the BASS and TREBLE
control to adjust the sound
to suit your own taste, as well as the acoustic conditions
of the room.
Manual tuning (to receive a weak broadcast)
1. Press the AM switch for AM reception or the FM switch
for FM reception.
2. Set the AUTO/MANUAL switch to MANUAL (latched).
3. To receive a weak broadcast, set the FM MODE switch to
MONO.
The muting will be released in FM mode.
4. Press the UP (m) or DOWN
(4) switch to start the tuning
system
in the direction of the desired station.
Release
when the frequency display shows your station.
If the
tuning does not stop at your station, tap the UP (>) or
DOWN (#) switch.
5. Adjust the VOLUME
CONTROL
to the desired listening
level and use the BASS and TREBLE controls to adjust
the sound to suit your own taste.
Preset procedures
Up to 6 stations can be preset in both the AM
and FM
bands. The preset procedure is as showbn below.
1. Press the AM
switch for AM
station presetting or FM
switch for FM station presetting.
2. With the auto or manual tuning, tune the unit to the de-
sired station.
3. Press the MEMORY button.
4. Press one of the PRESET STATION
button within 5 se-
conds after the MEMORY button is pressed.
Note:
Auto tuning
@ Turn the power on.
1. When a PRESET STATION button is pressed to preset a new fre-
quency, the old frequency is cleared and the new frequency is
stored.
2. Ahigh performance battery unit is built in the unit. Therefore, the
contents of the memory are not cleared when the power switch
is turned OFF. This battery is a lithium tyoe and will last about
10 years.
3. Do not press the MEMORY and PRESET STATION button simul-
taneously.
8
KR-930(K)
@ Select AM or FM.
() Press on either side.
® @ Set these switches to
out position.
By
©®
Adjust these controls as
your preference.
Manual tuning
AUTO/
MANUAL
O
oO
AUTOX
Set to MAMUAL.
= MANUAL
AM
FM
PHONO
< DOWN
UP >
TUNING —
Press on either side.
Preset procedures
PHONO
<< DOWN
UP >»
Press on either side to tune
to the desired station.
Select AM or FM.
MEMORY
;
2
.
4
5
6
— PRESET STATION
C
Press the PRESET STATION button.
Press the MEMORY
button.
Advertisement
Table of Contents
