Adjusting The Volume - Korg KR-11 Quick Start Manual

Quick Start Guide
Monitor speakers
Headphones/line out jack
Headphones
Volume dial
Buttons 1–14
(pads)
Powering this unit
You can use either batteries (sold separately) or an AC adapter
(sold separately).
When using batteries
1
Open the battery cover on the bottom of this unit.
2
Install four AA alkaline batteries, while making sure to
observe the correct polarity (+, -).
3
Close the battery cover.
Note: When the batteries run low,
Please replace the batteries.
Using the AC adapter
Connect the dedicated Korg AC adapter (sold separately) to
the DC 9V jack .
Make sure to only use the specified AC adapter. Using any AC
adapter other than the specified model could cause a
malfunction.
Genre selector
max.
min.
blinks on the display.
Thank you for purchasing the Korg KR-11 Compact Rhythm Box.
En
To help you get the most out of your purchase, please read this
manual carefully.
TAP button
Tempo knob
Display
Connecting headphones or similar devices
When connecting headphones or monitor speakers
Aside from the built-in speaker, you can output sound to a pair
of headphones or monitor speakers.
1
Connect the 3.5 mm stereo mini phone jack of your headphones
or similar device to the headphone/line out jack
Do not use four-conductor (TRRS) plugs.
Be sure that your monitor speakers are turned off before you
connect them to the KR-11.
Note: No sound is heard from the built-in speaker while a plug is
connected to the headphones/line out jack
Turning the power on/off, adjusting the volume
Turning the power on
1
Turn the volume dial
minimum setting.
2
Long-press the power button
3
Turn the volume dial
appropriate level.

Adjusting the volume

1
Turn the volume dial
from the built-in speaker
Turning the power off
1
Keep holding down the power button
goes dark.
This unit automatically turns off if the buttons and knobs are
not used for a certain length of time (the auto power-off
function). This is set to one hour by factory default.
5
AC adapter
DC 9V jack
Speaker
Power button
PATTERN LED
PAD LED
MODE button
button
FILL 1, 2 buttons
(pads)
.
.
all the way counterclockwise to the
to turn the unit on.
clockwise to raise the volume to an
to adjust the volume of sound that's output
or headphones/line out jack
until the display
.