Assembly
●
Always raise the backrest. (EN11 steps 4 to 5)
If the backrest is collapsed, the armrest cannot be installed correctly.
●
Be careful not to get your fingers trapped.
1
Place the controller on the seat so
that the controller cord passes over
the thigh massage section
( Do not trap the controller cord when installing armrests)
2
Check the "Right" and "Left" markings
on the underside of the armrest and the
hook catch part on the inside
<Inner side of armrest>
3
Attach the right hand side armrest
to the main unit
① H old the
side with both hands from the outside
② Hook the inside hooks onto the hooks (blue) on the side of
the main body and lower the armrests along the main body
●
Make sure that the controller cord is not trapped.
<Outside of armrest>
Holding
area
Hook
(blue)
EN12
Underneath the plastic part
part of the armrest on the right hand
Hook catch part (inside)
Thigh Massage Section
Hook catch part (inside)
Right hand side
Left hand side
4
Slide the armrests
back
●
Make sure that the hooks (blue)
on the side of the main unit are not
visible through the gap between the
main unit and the armrest.
If the hook (blue) is
visible, the armrest is
not attached correctly.
×