Recording And Playback Using An Audio Timer - Pioneer CT-We620R Operating Instructions Manual

| RECORDING AND PLAYBACK USING AN AUDIO TIMER
WAKE-UP PLAYBACK (Deck I or Deck II)
_— —— =] tk [——— =]
—) c= oO
(1)
. Load the tape(s) for playback.
@ Timer playback always begins in the forward direction.
Make sure that the tape(s) are properly rewound.
. Set the DOLBY NR switch.
. Set the REV MODE switch.
@ Not necessary for playback on DECK | of the CT-W402R.
. Set the stereo amplifier for tape playback.
@ Adjust the volume level by playing back a portion of the
tape.
. Rewind the tape to the position where playback is to
start.
. Set the audio timer.
@ When the timer is set, it will turn off the power of all con-
nected components.
. Set the TIMER mode switch to the PLAY position.
@ At the time set on the audio timer, the power will be turned
on and playback will begin automatically.
NOTES:
18
Operations depend on the type of audio timer used; be sure to
consult the operating instructions of the audio timer you ac-
tually use.
When a tape is inserted into both DECK | and DECK II, relay play-
back from DECK | to DECK I! will be performed when the power
comes on.
The blank skip function will operate during wake-up playback
(See page 11).
When not performing timer operations, set the TIMER mode
switch to the OFF position. Otherwise, playback might begin
unexpectedly when the power is turned on.
<RRB1130>
En
UNATTENDED RECORDING
CT-W602R: DECK | and/or DECK II
CT-W620R/CT-W502R/CT-W420R/CT-W402R: DECK Ii only
kh WD
"I Oo o1
. Load the tape(s) for recording.
® Timer recording always begins in the forward direction.
Make sure that the tape is properly rewound.
. Set the DOLBY NR switch.
. Set the REV MODE switch.
. Prepare the audio source.
@ Set the amplifier input selector to tuner, then tune in the
desired station.
. Press the recording (@) button.
. Adjust the recording level.
. Set the audio timer.
_ @ When the timer is set, it will turn off the power of all con-
nected components.
. Set the TIMER mode switch to the REC position.
@ At the preset time, the power will be turned on, and record-
ing will begin automatically.
NOTE for CT-W602R:
When tapes are inserted into both DECK | and DECK Il, relay re-
cording from DECK | to DECK II will be performed when the
power comes on.
NOTES:
Timer recording will not work if the erasure prevention tabs of
the tape loaded in Deck Il have been removed.
Operations depend on the type of audio timer used; be sure to
consult the operating instructions of the audio timer you ac-
tually use.
When not performing timer operations, set the TIMER mode
switch to the OFF position. Otherwise, recording might begin
unexpectedly when the power is turned on.
Turn down the volume of the amplifier if you do not wish to
listen to the program while it is being recorded.