Warranty - Magic Chef MCSFLW24W1 User Manual

FAULT
Unsatisfactory
washing result.
As soon as the
washer is loaded with
water, it discharges.
No water in the drum
while washing
Laundry has
detergent residue.
Grey spots appear
on the laundry.
The spin cycle does
not happen or is
delayed.
ERROR CODES
Your Washing Machine is equipped with a built-in fault detection system, indicated by a combination of
flashing wash operation lights. The most common failure codes are shown below.
TROUBLE CODE
The door is not shut properly.
E01
The water level or pressure or
E02
inside the washer may be low.
The pump or it's electrical
E03
connect is faulty or the
pump filter is clogged.
Your washer has an
E04
excessive amount of water.
POSSIBLE CAUSE
Hard water.
Laundry is too tightly packed.
The end of water drain hose is
too low for the machine.
No fault. Water is in the unseen
part of the drum.
Undissolved detergent may
appear as white spots.
There is untreated oil, cream
or ointment on your laundry.
No fault. The Unbalanced load
control system has been
activated.
POSSIBLE FAULT
TROUBLESHOOTING
Increase the amount of detergent following
the manufacturer's instructions.
Check that your laundry is spread out.
Check that the drain hose is at the correct
height.
. . . . . . . . . . . . . . . . . . . . .
Perform an extra rinse, or clean your laundry
with a brush after it dries.
Use the amount of detergent as instructed on
the packaging in the next wash.
The Unbalanced load control system will try to
spread your laundry. The spin cycle will begin
once the load is balanced. Load the drum
evenly for the next wash.
WHAT TO DO
Shut the door until it clicks. If the error persists, turn
off the washer, unplug it and contact customer
service or an authorised service agent.
Verify that the tap is fully open and that the water
is on. If the problem persists, the unit will stop after
a while. Unplug the washer, turn off your tap and
contact customer service or an authorized service
agent.
Clean the pump filter. If the problem persists,
contact customer service or an authorized
service agent.
The unit will discharge water by itself. Once the
water has drained, turn it off and unplug it. Turn
off the tap and contact customer service or an
authorized service agent.
21