Table of Contents
Advertisement
FIGURE 4 - Output Jacks
4. REAR PANEL OUTPUT CONNECTORS
(Figure 4)
All output connections are unbalanced to ground
and made through standard 1/4 inch phone jacks.
Each output is capable of driving a 600 ohm. or
greater, load to a maximum level of +20 dB. (See
Specifications for details)
In the 52 Series mixer every output is "polarity
coherent", that is, a positive
going signal in any
input or insert point will produce a positive going
signal at every output.
4A. SUB R
RIGHT SUBGROUP OUTPUT
This high level output is derived by summing
all
of
the
inputs
(channels
& external)
assigned to the right subgroup bus. A PAN
control rotated full clockwise to the "R"
position will assign that signal only to the
right bus.
4B. SUB L
LEFT SUBGROUP OUTPUT
4C. MAIN OUTPUT
The MAIN OUT jack is a line level output
that is a 50/50 mix of the right and left
subgroups. Since the "52" is a true sub¬
group mixer all signals that appear in the
main
mix
must
come
through the
sub¬
group busses.
4D. MONITOR OUTPUT
The MONITOR OUT jack has a line level
signal that is the sum of all of the input
channel assignments and the external monitor
input signal.
4E.
EFFECTS SEND
1 he EFFECTS SEND output signal is the sum
of all of the input channel assignments with
the EFX/REV control plus any signal coming
through the EFX IN.
ten
his high level output is the left subgroup
equivalent ot the Sub R output.
Advertisement
Table of Contents
